Husqvarna K970 SmartGuard Workshop Manual page 21

5.2.9 To remove the inlet nozzle
1. Remove the screw for the inlet nozzle.
2. Remove the the inlet nozzle.
3. Install in opposite sequence.
5.2.10 To remove the vibration damping units
1. Remove the air filter and the cylinder cover. Refer to
To remove the cylinder cover on page 17 .
2. Remove the starter. Refer to
on page 15 .
3. Loosen the cable lug on the ignition module and on
the stop button. Remove the air line. Refer to
remove the air duct on page 18 .
4. Disconnect the water hose from the valve. Refer to
To disassemble the wet system on page 66 .
5. Remove the fuel hose. Refer to
carburetor on page 17 .
6. Remove the throttle wire from the carburetor. Refer
To remove the carburetor on page 17 .
to
7. Remove the choke. Refer to
carburetor on page 17 .
1451 - 001 - 02.04.2020
To remove the starter
To
To remove the
To remove the
8. Remove the 4 screws for the vibration damping
units.
Product overview for repair and
servicing - 21