Advertisement
Available languages
Available languages
Parts require
None.
High altitude adjustment is not required for proper operation of this engine.
Note: Every hedge trimmer is run at the factory and the carburetor is set in compliance
with emission regulations. This carburetor does not have acceleration and high-speed
adjustment needles.
Check idle speed and reset if necessary. If a tachometer is available, idle speed screw
(H) should be set to the specifications found in specifications part of this manual. Turn
idle screw (H) clockwise to increase idle speed; counter clockwise to decrease idle
speed.
Warning! When carburetor adjustment is completed, the cutting attachment
should not move at idle, otherwise serious personal injury may result.
Lubricating blades (Level 1)
Fig. 23 - 25
Tools required:
1 Clean rag
1 Cleaning brush, 25 mm or 50 mm (1" or 2")
Parts required:
1 Engine Oil, 20 W (lubrication)
1 Mixture of kerosene and 20W oil, 50-50 (cleaning).
Warning! Hedge Trimmer blades are very sharp. Wear gloves to protect
hands.
● Disconnect spark plug wire from spark plug.
● Brush loose debris from blade and coat both sides of blade with the 50-50 cleaning
mixture.
● Allow cleaning mixture to soften the remaining gummy residue then wipe it from the
blade.
● Apply clean oil to the entire length of the blade. Be certain the blade bolts are
lubricated.
● Wipe excess oil from the blade before putting the hedge trimmer back in service.
Lubricating gear box assembly (Level 1)
Fig.26 - 27
Tools required:
1 Grease Gun
52
Advertisement
