Advertisement
Available languages
Available languages
Clear the work area
Fig. 4
Spectators and fellow workers must be warned, and children and animals prevented
from coming nearer than 15 m (50 ft.) while the hedge trimmer is in use.
Keep a firm grip and a solid stance
Fig. 4
● Hold the front and rear handles with both hands, with thumbs and fingers encircling
the handles.
● Maintain footing and balance at all times. Do not stand on slippery, uneven or
unstable surfaces. Do not work in odd positions or on ladders. Do not over reach.
Turnable handle
Fig. 5
To have good control during operating, the hedge trimmer is equipped with a turnable
handle. The handle can be rotated to several angles: 45° and 90° counterclockwise +
45° and 90° clockwise.
● Press the red blocking-switch (A) downwards and rotate the handle to the desired
angle.
● Press this blocking-switch(A) again and rotate the handle till it clicks into the
correct position. The blocking-switch(A) will automatically return into its original
position.
● Check if the handle is now blocked in the new position.
Avoid Hot Surfaces
Keep exhaust area clear of flammable debris. Avoid contact during and immediately
after operation.
Warning! Never perform blade maintenance procedures while engine is
running.
Equipment check
Warning! Use only we approved attachments. Serious injury may result
from the use of a non-approved attachment combination. we will not be
responsible for the failure of cutting devices, attachments or accessories
which have not been tested and approved by we. Read and comply with
all safety instructions listed in this manual and safety manual.
● Check hedge trimmer for loose/missing nuts, bolts, and screws. Tighten and/ or
replace as needed.
● Inspect fuel lines, tank, and area around carburetor for fuel leaks. Do not operate
hedge trimmer if leaks are found.
● Inspect shield for damage. Ensure that the blade stiffener is securely in place.
Replace if either is damaged or missing.
45
Advertisement
