Advertisement
Available languages
Available languages
5. Choke
The choke control lever is located on the front of the air cleaner case. Move choke lever
to "Cold start" position to close the choke for Cold Starting. Move choke lever to "RUN"
position to open choke.
6. Primer bulb
Pumping primer bulb before starting engine draws fresh fuel from the fuel tank priming
the carburetor for starting. Pump primer bulb until fuel is visible and flows freely in the
clear fuel tank return line. Pump bulb an additional 4 or 5 times.
7. Air cleaner
Contains replaceable filter element.
8. Recoil starter handle
Pull handle slowly until recoil starter engages, then quickly and firmly. Do not pull rope
all the way out or allow the handle to snap back, damage to the starter will occur.
9. Fuel tank
Contains fuel and fuel filter.
10. Fuel tank cap
Covers and seals fuel tank opening.
11. Rear handle
Contains Stop switch, Throttle trigger lockout and Throttle trigger.
12. Throttle trigger lockout
This lever must be depressed first before throttle trigger can be activated.
13. Throttle trigger
Spring loaded to return to idle when released. Trigger lockout must be depressed fully
before Throttle trigger will move. During acceleration, depress gradually for best
operating technique.
14. Ignition switch
"Ignition switch " located on the top of the rear handle. Press switch "I" to Run, press
"STOP" to Stop.
15.. "Blocking" switch
Pulling the "Blocking" switch, the handle can be rotated to several angles: 45º and 90º
counterclockwise+45ºand 90ºclockwise for good control during operation.
16. Muffler
The muffler controls exhaust noise and emission. Keep exhaust area clear of
flammable debris.
40
Advertisement
