Max Twintier RB611T Instruction Manual And Safety Instructions page 17

switch at "ON" and the trigger lock (2) at
"UNLOCK".
2-3 (Fig.21) Tilt the tool 45° angle to the crossed
rebars.
2-4 (Fig.22) Align the Center mark (a) to the
center of the crossed rebars.
2-5 Once pull the Trigger, the tool automatically
completes a series of tying actions (feeding,
cutting, gripping and tying).
WARNING
• (Fig.23) When the Main switch (Fig.1.e) is
turned "ON", the Hook (Fig.1.f) of the tip
rotates automatically for initializing,
absolutely do not bring your fingers close
to any rotating and moving part.
• Do not touch any rotating and moving part
such as hook of the tip or the Tiewire
during the tying work (while the machine is
operating).
3. How to remove the Tiewire
(Fig.6) Set the Main switch (e) at "OFF", the
Trigger lock (2) at "LOCK" and remove the
Battery pack (5).
3-1 (Fig.9) Press the Release button (8) of the
tool and confirm that the Release button is
caught in the Release stopper (9).
3-2 (Fig.11) Rotate the Magazine stopper (6) to
open the Magazine cover.
3-3 (Fig.24) Remove the Tiewire from the
Magazine.
3-4 (Fig.25) Remove the wire with the plastic
piece from the Wire guide.
4. When the Tiewire runs out
(Fig.26) The plastic piece comes off when it is
used up normally, and can be discarded
separately as plastic and metal wire. (About 20
cm remains after normal use)
(Fig.6) Set the Main switch (e) at "OFF", the
Trigger lock (2) at "LOCK" and remove the
Battery pack (5).
5. Tension adjustment
(Fig.27.c) This dial allows you to adjust wire
tension torque slightly. To increase the tension,
turn it in the counterclockwise. To decrease the
tension, turn it in the clockwise.
6. Auto Power-off feature
This tool has "Auto Power-off" feature, which
saves the power consumption of the Battery
when the tool is not operated.
If the tool is not operated for 30 minutes, the tool
is automatically turned off. When the power is
turned off automatically, turn the Main switch
OFF and ON again to operate the tool.
7. For proper tightness
7-1 (Fig. 21) Tilt the tool 45° angle to the crossed
rebars.
7-2 (Fig.22) Align the Center mark (a) to the
center of the crossed rebars.
7-3 (Fig.28) Apply the tool perpendicularly to the
surface of the crossed rebars.
During tool operation
Do not move the tool during tying operation until
the tool stops tying automatically.
7-4 (Fig.29) Tie in alternate direction.
7-5 (Fig.30) Cross tying.
Bent the knot of the first tie before making
the second tying.
8. How to reload previously used
Tiewire
(Fig.31) Without twisting the 2 wires, insert them
into the Wire guide (i).
9. To use TW1061T-S (Stainless
wire)
Please contact your dealer or MAX to have your
RB441T modified to Stainless Mode.
CAUTION
Use of TW1061T-S with un-modified RB441T
can lead to severe wire jams.
13.STORAGE AND
MAINTENANCE
Do not store the tool in a cold weather
environment. Keep the tool in a warm area.
When not in use, the tool should be stored in a
warm and dry place. Keep out of reach of
children.
17