Max Twintier RB611T Instruction Manual And Safety Instructions page 16

12. OPERATING INSTRUCTIONS
1. How to set the Tiewire
(Fig.6) Set the Main switch (e) at "OFF", the Trigger lock (2) at "LOCK" and remove the Battery
pack (5).
CAUTION
• Be careful not to drop or give a strong impact to the Tiewire. It may cause the damage and the
malfunction of the tool.
• Beware of the tip of the wire when you pick up the Tiewire. It might cause an injury.
1-1 (Fig.9) Press the Release button (8) of this tool, and confirm that the Release button is caught in
the Release stopper (9).
1-2 (Fig.10) Stretch out the tip of the wound Tiewire.
BE SURE TO USE ONLY THE SPECIFIED TIEWIRE (MAX TW1061T Series).
The use of binding wire that has not been specified may cause breakdown of this tool. Therefore, be sure
only to use the specified MAX TW1061T series.
RB441T, RB611T is not compatible with TW898 series or TW1525 series.
DO NOT USE RUSTY WIRE.
The use of the rusty wire may cause functional trouble of the tool.
1-3 (Fig.11) Rotate the Magazine stopper (6) 45° counterclockwise.
1-4 (Fig.12,13) Open the Magazine cover (n) and set the Tiewire in the Magazine (7) with the Holding
slot (o) side of the reel facing up.
1-5 (Fig.14) Grasp the tool with the left hand, hold the tip of the wire with the right hand, and remove the
wire from the Holding slot.
NOTICE
The 2 wire tips of new Tiewire are twisted.
1-6 (Fig.15) Straighten out the tip of the wire, and insert the twisted wire into the Wire guide (i) parallel.
1-7 (Fig.16) Confirm through the Window that the twisted part of wire has reached past two Feeding
gears (h).
1-8 (Fig.17) Press the Release stopper (9) up, and confirm that the Release button has been raised up.
1-9 (Fig.18) Close the Magazine cover and rotate the Magazine stopper 45° clockwise.
If the Window is dirty
Open the Window (Fig.1.g) and wipe off the dirt on the inside of the Window with a cloth. Close the
Window again after cleaning to ensure that foreign objects will not be able to enter the tool.
2. How to operate RB441T/RB611T
(Fig.6) Set the Main switch (e) at "OFF", the Trigger lock (2) at "LOCK" and remove the Battery
pack (5).
2-1 (Fig.19) Mount the Battery pack on the tool's main body until a click is heard.
2-2 (Fig.20) When Main switch (e) is turned "ON", the Hook (Fig.1.f) of the tip rotates automatically
for initializing, absolutely do not bring your fingers close to any rotating and moving part. Set the Main
16