General Specifications - Pioneer ELITE VSX-LX305 Instruction Manual

General Specifications

Amplifier Section
Rated Output Power
Maximum Effective Output Power
THD+N (Total Harmonic Distortion + Noise)
Input Sensitivity and Impedance
Rated RCA Output Level and Impedance
Phono Maximum Input Signal Voltage
Frequency Response
Tone Control Characteristics
Signal to Noise Ratio
Speaker Impedance
Headphone Rated Output
Supported impedance of Headphones
Headphones Frequency Response
North American models
With 8 ohm loads, both channels
driven, from 20 Hz - 20 kHz; rated
100 watts per channel minimum
RMS power, with no more than 0.08
% total harmonic distortion from 250
milliwatts to rated output. (FTC)
225 W at 6 ohms, 1 kHz, 1 ch driven
of 10% THD
0.08% (20 Hz - 20,000 Hz, Rated output power)
200 mV/47 kΩ (LINE(RCA)), 3.5 mV/47 kΩ (PHONO MM)
ZONE B LINEOUT, ZONE 2 PRE/LINEOUT : 200 mV/1 V/2.2 kΩ
10 Hz - 100 kHz/+1 dB, –3 dB (Direct/Pure Direct)
MAIN : ±10 dB, 20 Hz (BASS), ±10 dB, 20 kHz (TREBLE)
ZONE 2 : ±10 dB, 100 Hz (BASS), ±10 dB, 10 kHz (TREBLE)
106 dB (IHF-A, LINE IN, SP OUT), 80 dB (IHF-A, PHONO IN, SP OUT)
European models
9 ch × 170 W at 6 ohms, 1 kHz, 1 ch driven of 1% THD (IEC)
185 W at 6 ohms, 1 kHz, 1 ch driven
of 10% THD (JEITA)
PREOUT (SUBWOOFER) : 1 V/470 Ω
70 mV (MM 1 kHz 0.5%)
4 Ω - 16 Ω
85 mW + 85 mW (32 Ω, 1 kHz, 10% THD)
8 Ω - 600 Ω
10 Hz - 100 kHz
Appendix
Australian and Asian models
9 ch × 185 W at 6 ohms, 1 kHz, 1 ch
driven of 10% THD (JEITA)
184