Table of Contents
Advertisement
> Specifications
> Advanced Setup > Listening Modes > Network Functions
General Specifications
■ Amplifier Section
Rated Output Power (FTC) (North American)
With 8 Ω loads, both channels driven, at 1 kHz;
rated 120 watts per channel minimum RMS power,
with no more than 0.08% total harmonic distortion
from 250 milliwatts to rated output.
With 6 Ω loads, both channels driven, at 1 kHz;
rated 150 watts per channel minimum RMS power,
with no more than 1% total harmonic distortion from
250 milliwatts to rated output.
Rated Output Power (European and Australian)
7 ch × 180 W at 6 Ω, 1 kHz, 1 ch driven of 1% THD
7 ch × 220 W at 4 Ω, 1 kHz, 1 ch driven of 1% THD
Rated Output Power (Asian, 220-230/240 V)
7 ch × 180 W at 6 Ω, 1 kHz, 1 ch driven of 1% THD
7 ch × 220 W at 4 Ω, 1 kHz, 1 ch driven of 1% THD
Continuous Power Output (North American)
1 kHz, 2 ch driven of THD 0.08% at 8 Ω:
120 W+120 W (Front)
120 W (Center)
120 W+120 W (Surround)
120 W+120 W (Surround back/Height)
1 kHz, 2 ch driven of THD 1% at 6 Ω:
150 W+150 W (Front)
150 W (Center)
150 W+150 W (Surround)
150 W+150 W (Surround back/Height)
1 kHz, 2 ch driven of THD 1% at 4 Ω:
200 W+200 W (Front)
200 W (Center)
200 W+200 W (Surround)
200 W+200 W (Surround back/Height)
Maximum Effective Output Power (North American)
225 W at 6 Ω, 1 kHz, 1 ch driven of 10% THD
Multi Channel Simultaneous Output Power
2
560 W (7 ch total) at 8 Ω, 1 kHz, All ch driven total
power of 1% THD
Maximum Output Power (Australian, 220-230 V)
300 W (4 Ω, 1 kHz, 1 ch driven of 10% THD)
Maximum Output Power (Asian, 220-230/240 V)
300 W (4 Ω, 1 kHz, 1 ch driven of 10% THD)
THD+N (Total Harmonic Distortion+Noise)
0.05% (1 kHz, 100 W, 8 Ω)
Input Sensitivity and Impedance
200 mV/82 kΩ (LINE (RCA))
3.5 mV/47 kΩ (PHONO MM)
Rated RCA Output Level and Impedance
1 V/470 Ω (SUBWOOFER PRE OUT)
200 mV/2.2 kΩ (ZONE LINE OUT)
2 V/2.2 kΩ (ZONE PRE OUT)
Phono Overload
70 mV (MM 1 kHz 0.5%)
Tone Control Characteristics
±10 dB, 20 Hz (BASS)
±10 dB, 20 kHz (TREBLE)
Signal to Noise Ratio
105 dB (IHF-A, LINE IN, SP OUT)
80 dB (IHF-A, PHONO IN, SP OUT)
Speaker Impedance
4 Ω - 16 Ω
Headphone Output Impedance
43 Ω
Headphone Rated Output
55 mW (32 Ω, 1 kHz, 10% THD)
■ Video Section
Signal level
1 Vp-p/75 Ω (Composite Video)
1 Vp-p/75 Ω (Component Video Y)
0.7 Vp-p/75 Ω (Component Video B/R)
Maximum resolution supported by component video
480i/576i
■ Tuner Section
FM Tuning Frequency Range
> Basic Manual
Troubleshooting
|
Supplementary Information, etc.
87.5 MHz - 107.9 MHz (North American)
87.5 MHz - 108.0 MHz, RDS (Others)
AM Tuning Frequency Range
530 kHz - 1710 kHz (North American)
522/530 kHz - 1611/1710 kHz (Others)
Preset Channel
40
■ Network Section
Ethernet LAN
10BASE-T/100BASE-TX
Wireless LAN
IEEE 802.11 a/b/g/n standard
(Wi-Fi
standard)
R
5 GHz/2.4 GHz band
■ BLUETOOTH Section
Communication system
BLUETOOTH Specification version 4.1+LE
Frequency band
2.4 GHz band
Modulation method
FHSS (Freq Hopping Spread Spectrum)
Compatible BLUETOOTH profiles
A2DP 1.2
AVRCP 1.3
HOGP-Host (Client)
HOGP-HID Device (Server)
HID Service (HIDS)
Supported Codecs
SBC
AAC
Transmission range (A2DP)
20 Hz - 20 kHz (Sampling frequency 44.1 kHz)
Maximum communication range
Line of sight approx. 15 m (＊)
½ The actual range will vary depending on factors
such as obstacles between devices, magnetic fields
around a microwave oven, static electricity, cordless
phone, reception sensitivity, antenna's performance,
Advertisement
Chapters
Table of Contents
