Table of Contents
Advertisement
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Varmebaronen Vedolux 30
Summary of Contents for Varmebaronen Vedolux 30
- Page 1 Installation, operation and care Vedolux 30 2011-03-31 xxxxxx SMOKELESS...
-
Page 2: Table Of Contents
Contents Vedolux 30 11.03 General.....................2 Firewood...................9 Firewood as a fuel Notes....................3 Firewood Function....................4 Heat content Vedolux 30 First burning cycle Ceramic combustion chamber Firewood.as.a.fuel................10 Flue cleaning First burning cycle Chimney Lighting a fire without gas... -
Page 3: Notes
Notes Vedolux 30 11.03 To be completed when the Vedolux 30 is installed! Serial number: ............................Installation date: ............................Installer: ............................Tel: ............................Other: ...................................................................................................................................................................... Illustrations may differ from the actual product Allowing for printing errors and errors on proofs... -
Page 4: Function
Vedolux 30 11.03 Chimney Vedolux.30 The Vedolux 30 has a suction fan minimizing the chimney require- • is a firewood boiler with a suction fan, designed for heating houses ments of the boiler. and smaller properties. • is environmentally-approved for firewood burning with an accumu- lator tank. -
Page 5: Technical.data
Technical.data Vedolux 30 11.03 Weight empty Firewood.hatch w x h11.8 x 9.7 in filled with water Chimney.requirement height 11.5 ft Volume flue duct recommended Ø 5.71 Design.pressure 25.6 Test.pressure flue duct Ø 4 Pressure.drop water flow 0.14 gal/s 0.145 12,6 Design.temperature... -
Page 6: Installation
Chimney area to be heated. Allow for 2 – 3 gal of tank volume per 10 ft The Vedolux 30 has a suction fan minimizing the chimney require- heated surface area. ments. -
Page 7: Cooling Coil - Temperature Limiter
The boiler has a cooling coil which, combined with a suitable thermal Pellet.burner/oil.burner valve, is used to prevent the boiler temperature exceeding 230°F if The Vedolux 30 is primarily designed to be fired by firewood, but can the water boils. Follow the instructions of the valve manufacturer. -
Page 8: Electrical.connection
Electrical.connection Vedolux 30 11.03 Electrical installation must be in accordance with the applicable regulations, under the supervision of an BLUE Supply YELLOW/GREEN authorised installer. BLACK Electrical.connection The boiler is connected directly to the mains. The electrical connections are at the rear of the boiler, in the form of... -
Page 9: Checks
Firewood.as.a.fuel The heat content is the amount of heat that can be extracted by the Vedolux 30 has a ceramic grate and an afterburning chamber made boiler and transferred to the boiler water. Heat content should not be of high-temperature resistant stainless steel. The boiler works on the confused with energy content, which increases with the size of the principle of reverse combustion. -
Page 10: Firewood.as.a.fuel
Firewood.as.a.fuel Vedolux 30 11.03 20. Main switch. 21. Thermostat for fan and charging pump. 22. Fan start when the boiler is cold. 25. Overheating protection. 26. I ndicator showing triggered overheat- ing protection. 27. T hermometer, displays the boiler RESET ALARM temperature. MAIN SWITCH START STOP 28. P ressure gauge showing the water pressure in the heating system. First.burning.cycle RISK OF BURNS First check that the combustion tunnel is firmly seated and that the Do not open the boiler hatches if the fan is not running air control pipe, 34a, has not moved during transport. -
Page 11: Cleaning
Cleaning Vedolux 30 11.03 When cleaning, the boiler must be completely cool and Ashes may contain embers for a long time after the all embers must have died. burning cycle, so keep them in a non-flammable con- Disconnect the power supply to the boiler before cleaning. -
Page 12: Operation.and.care
Operation.and.care Vedolux 30 11.03 Ceramic.-.combustion.tunnel Unvented.expansion.system The ceramic grate and combustion tunnel are wearing parts that The pressure in the unvented expansion vessel should be checked will have to be replaced over time. Wearing parts are not covered by at intervals of several years. The vessel must not be exposed to any any guarantee. -
Page 13: Problems.burning.firewood
Problems.burning.firewood Vedolux 30 11.03 The most common problems that occur when burning firewood are usually the result of the boiler failing to reach a high enough temperature so that the boiler never really gets going. Another common problem is that the heat is not transferred to the accumulator tanks even though the wood is burning well in the boiler. -
Page 14: Component.specification
Component.specification Vedolux 30 11.03 item prod.no. name qty. 12 00 17 Overheating protection 1-pole, alt. 110°C 12 00 53 Thermostat 1-pole 100-500°C 12 00 09 Handle thermostat 13 00 31 Switch 2-pole, auto-return 13 00 32 Switch 2-pole 16 00 01... - Page 16 Värmebaronen AB retains the right to change the specification of included components without prior notice, as part of its policy of continuous improvement and development. Värmebaronen AB +4644-226320 Arkelstorpsvägen 88 +4644-226358 291 94 Kristianstad www.varmebaronen.se Sweden info@varmebaronen.se...
Need help?
Do you have a question about the Vedolux 30 and is the answer not in the manual?
Questions and answers