Varmebaronen Vedolux 37 Installation, Operation And Maintenance Manual
Firewood boiler
Hide thumbs
Also See for Vedolux 37:
- Installation, operation and maintenance manual (16 pages) ,
- Installation operation and care (16 pages) ,
- Installation, operation and maintenance manual (12 pages)
Subscribe to Our Youtube Channel
Related Manuals for Varmebaronen Vedolux 37
Summary of Contents for Varmebaronen Vedolux 37
- Page 1 1 7 0 8 2 3 V 3 7 U S r e v 4 Installation, operation and maintenance Firewood boiler Vedolux 37...
-
Page 2: Table Of Contents
Agency’s cord wood emission limits for wood heaters sold the burner, the process or the surroundings. after May 15, 2020. Under specific test conditions, the heater has been shown to deliver heat rates as specified in the techni- cal data in this manual. Värmebaronen Vedolux 37... - Page 3 Notes To be completed when the Vedolux 37 is installed! Serial number: ............................Installation date: ............................Installer: ............................Tel: ............................Other: ...................................................................................................................................................................... Värmebaronen Vedolux 37...
-
Page 4: Function
Chimney and thereby the efficiency, if the installation is located in a heated area The Vedolux 37 has a suction fan minimising the chimney require- the heat losses will be smaller and if the heat losses can be used to ments of the boiler. -
Page 5: Technical Data
15.7 14. Expansion connection, 1” BPT*. 19. Base frame, accessory. Clearance to combustibles. * Use the delivered NPT adapters for these connections. 12” sides and rear, 18” top and 36” front. The NPT adapter builds 2.2”. Värmebaronen Vedolux 37... -
Page 6: Installation
Chimney The schematic diagram below shows the Vedolux 37 with the Vedolux 37 has a suction fan minimizing chimney requirements. Aqualux CU and Aqualux UB accumulator tanks plus Accumulator Control 3. For more details, refer to the documentation supplied with the relevant product. -
Page 7: Function Of Accumulator Control
The expansion vessel is best connected using ½” cop- perpipe, as shown in the diagram on the previous page. The Vedolux 37 is primarily designed to be fired by firewood, but can also be modified for pellets using a pellet burner. -
Page 8: Electrical Connection
An thermostat limits the boiler’s working temperature. starts. When the time set for the time relay, 30 minutes, is reached, the contact changes, which means that the fan and the charging pump for the accumulator system are controlled by the thermostat, 21. Värmebaronen Vedolux 37... -
Page 9: Checks
3000 Firewood as a fuel content Vedolux 37 has a ceramic grate and an afterburning chamber made of high-temperature resistant stainless steel. The boiler works on the The chart illustrates how the heat content changes. principle of reverse combustion. If the boiler is correctly operated, it... -
Page 10: Firewood As A Fuel
Push down. The pin at gas temperature has fallen to below 250°F, the bottom of the ash the fan and charging pump to the accumula- hatch engages with the tor stop running. hole in the ash plate. Värmebaronen Vedolux 37... -
Page 11: Flue Cleaning
• Clean the fan blades carefully so they keep their shape. You are tive layer of a couple of centimetres. recommended to use a paintbrush. Clean the chamber around the combustion tunnel. • Replace the fan and connect the cables. Close all hatches and dampers. Värmebaronen Vedolux 37... -
Page 12: Operation And Maintenance
The expansion vessel takes up the changes in volume. The There is a risk of flames exiting through the hatch, flow temperature – and therefore also the pressure – is higher in so take the greatest possible care! the summer than the winter. Värmebaronen Vedolux 37... -
Page 13: Problems Burning Firewood
Expansion vessel too small. See the section about the “Expansion system” on page 5. the system is warm. Initial pressure in the expansion Check the pressure in the vessel, see the section about the vessel too high/low. “Expansion system”. Värmebaronen Vedolux 37... -
Page 14: Component Specification
71 02 00 Damper arm 71 02 57 Inner ash hatch 71 02 60 Turbulator tool 71 02 61 Inner damper of draught hatch 904 56 Ash rake 909 21 Cleaning hatch 71 11 33 Flue pipe Värmebaronen Vedolux 37... - Page 15 Weight, empty 705 lb filled with water 970 lb Volume 32 gal Pressure, design 22 psi test 31 psi Pressure drop, water flow 0.14 gal/s 0.145 psi Temperature, design 220 °F operating max 220 °F Output wood, moisture content 16 ±4% 126 kBTU Output, pellets 143 kBTU...
- Page 16 Värmebaronen AB Arkelstorpsvägen 88 291 94 Kristianstad Sweden +4644-226320 +4644-226358 www.varmebaronen.se info@varmebaronen.se Värmebaronen Vedolux 37...
Need help?
Do you have a question about the Vedolux 37 and is the answer not in the manual?
Questions and answers