Qilive Q.6364 User Manual page 11

4.3 Level feet
If the appliance tilts in some way, adjust the height of the left/right foot (2) of the appliance
to be in a horizontal level ( Fig. 14).
Turn the foot (2) clockwise or counter clockwise to adjust the height.
Note: If the appliance is not level, the door and the door seal will not be closed properly.
4.4 Reverse door
Ensure the appliance is unplugged and empty. To take the door off, it is necessary to tilt
the appliance backwards. You should rest the appliance on something solid so that it will
not slip during the door reversing process. All parts removed must be saved to do the
reinstallation of the door. Do not lay the appliance flat as this may damage the coolant
system. It is better that 2 people handle the appliance during assembly.
1. Remove two screws at the rear of the top cover ( Fig. 1).
2. Remove the top cover and place it aside ( Fig. 2).
3. Unscrew the top hinge and then remove the upper door. Place it on a soft pad to
avoid scratches ( Fig. 3).
4. Unscrew the middle hinge and then lift the lower door to remove it. Place it on a soft
pad to avoid scratches ( Fig. 4).
5. Move the hinge hole covers from the left side to the right side ( Fig. 5).
6. Unscrew and remove the bottom hinge. Then remove the adjustable feet from both
sides ( Fig. 6).
7. Unscrew and remove the bottom hinge pin and, turn the bracket over and replace it
( Fig. 7a and Fig. 7b).
8. Refit the bracket fitting and the bottom hinge pin. Replace both adjustable feet
( Fig. 8).
9. Reverse the middle pin 180° and replace it in the left position in the upper hole of the
lower door. Then tighten the screws ( Fig. 9).
10. Place the upper door back on. Ensure the door is aligned horizontally and vertically
so that the seals are closed on all sides before finally tightening the top hinge
( Fig. 10).
11. Replace the top cover and fix it with 2 screws on the back ( Fig. 11).
12. Use a spanner to tighten it if necessary.
4.5 Install door handle
 Fig. 12.
4.6 Rear spacer
Screw the rear spacers at the rear of the unit ( Fig. 13).
4.7 Positioning
Install this appliance at a location where the ambient temperature corresponds to the
climate class indicated on the rating plate of the appliance. This ensures the correct
operation of the appliance.
Climate class
SN
N
ST
T
Ambient temperature
+10°C to +32°C
+16°C to +32°C
+16°C to +38°C
+16°C to +43°C
11
EN