Chapter 5. Loading Your Dishwasher - Kernau KDI 6543 User Manual

CHAPTER 5. LOADING YOUR DISHWASHER

For best results, follow these loading guidelines.
Loading the household dishwasher up to the capacity indicated by the manufacturer will contribute to energy
and water savings.
Manual pre-rinsing of tableware items leads to increased water and energy consumption and is not
recommended You can place cups, glasses, stemware, small plates, bowls, etc. in upper basket. Do not lean
long glasses against one another or they cannot remain steady and may receive damage.
When placing long stem glasses and goblets, lean them against the basket edge or rack and not against other
items.
Place all containers such as cups, glasses and pots into the dishwasher with the opening facing downwards
otherwise water can collect on items.
If there is cutlery basket in machine, you are recommended to use the cutlery grid in order to obtain the best
result. Place all large (pots, pans, lids, plates, bowls etc.) and very dirty items in the lower rack.
Dishes and cutlery should not be placed above each other.
WARNING:
Take care not to obstruct the rotation of spray arms.
WARNING:
Make sure after loading the dishes do not prevent opening the detergent dispenser.
RECOMMENDATIONS
Remove any coarse residue on dishes before placing the dishes in the machine. Start the machine with full
load.
Do not overload the drawers or place dishes in the wrong basket.
WARNING:
To avoid any possible injuries, place long-handle and sharp-pointed knives with their sharp points facing
down or horizontally on the baskets.
Top basket
These racks are designed to increase the capacity of the top
basket. You can place your glasses and cups on the racks.
You can adjust the height of these racks. Thanks to this
feature, you can place different sizes of glasses under these
racks.
Thanks to height adjustment plastics mounted on the basket,
you can use your racks in 2 different heights. In addition, you
can place long forks, knives and spoons on these racks
laterally, so that they do not block the revolution of propeller.
EN 42
1
2