Kernau KDI 6543 User Manual page 52

If the programme does not start:
• Check, if the plug is connected to the power socket.
• Check, the fuse.
• Check, if the water inlet is open.
• Check, if the device's door is open.
• Check, if the device is turned of with the On/OFF button.
• Check, if the filter on the water inlet or device filter are not blocked.
If in the detergent chamber remain the detergent residue:
Check, if the detergent was placed into wet detergent chamber.
If after ending the selected program, water is accumulated in the device:
• Check, if the exhaust water hose is clogged or bended.
• Check, if the filters are blocked.
• Check, if the program is not finished.
If during the washing cycle can be sounded the clicking or knocking noises:
• Check, if the dishes were improperly placed.
• Check, if the spray arms are hitting the dishes.
If the device interrupting the operation during washing cycle:
• Check, if power breakdown.
• Check, if water supply malfunction.
• Check, if the programe can be in standby mode.
If the partial food waster remains on the dishes:
• Check, if dishes placed incorrectly, sprayed water not reaching affected dishes.
• Check, if dishes leaning each another.
• Check, if not enough detergent used.
• Check, if wrong wash programme selected. Spray arms clogged with food waste.
• Check, if filter and water drain pump clogged or filter misplaced.
If whitish stains remain on dishes:
• Check, if not enough detergent used
• Check, if rinse and dosage and/or water softener set too low.
• Check, if high water hardness level
• Check, if salt compartment cap not closed properly.
If the dishes do not dry:
• Check, if drying option is not selected.
• Check, if rinse aid dosage set too low.
EN
52