anko 42713340 Instruction Manual

Wet&dry vacuum cleaner

Keycode: 42713340

WET&DRY Vacuum Cleaner

Please read all the information carefully before you use the device to avoid accidents and keep it for

future reference.

Specification

Power Source: DC12V 5A Max

Suction Power: 2.5-3kPa

Motor rating: 60W

Cord length: 4m

Start the car or other 12V DC power supply equipment.

Plug the power cord plug into the cigarette lighter.

Select a suitable vacuum cleaner suction nozzle according to the user environment.

Handle the vacuum cleaner, push forward the power switch to open the vacuum cleaner

and start to clean.

After using, push back the switch, turn off the vacuum cleaner. Press the dust collection

button and remove the dust cover to take out the filer. Shake off the dust or rinse with water.

It uses HEPA filter, it needs to dry out after cleaning. Keep the " ↑" mark (on HEPA filter)

Instruction Manual

Table of Contents

Do you have a question about the 42713340 and is the answer not in the manual?

Page 1 Instruction Manual Keycode: 42713340 WET&DRY Vacuum Cleaner Please read all the information carefully before you use the device to avoid accidents and keep it for future reference. Specification Power Source: DC12V 5A Max Suction Power: 2.5-3kPa Motor rating: 60W Cord length: 4m Operation Instructions Start the car or other 12V DC power supply equipment.
Page 2 UPWARD when assembling the HEPA filter. DO NOT immerse the motor in water. Collecting power lines and vacuum cleaner to finish the vacuum cleaning operation. Attention: Do not close to the heating dissipating hole or suction outlets during use. Never dismantle the product without due permission, else this may nullify warranty clauses. The dry and wet application can quickly suck the dry matter and few spilled liquid inside the car (except corrosive, flammable and explosive liquid).
Page 3 For New Zealand customers, this warranty is in addition to statutory rights observed under New Zealand legislation.