Connect Ip40 - liniLED Top Power Colour Manual

Connect IP40
1
3
4
The liniLED® IP40 Connector consists of: End cap (1), Shell (2),
Connector (3), Clamp (4).
3
Place the shell (2) over the LED strip. Make sure the side with the small-
est opening is put on first.
5
Slide the connector (3) sideways into the hollow chamber of the
liniLED® LED strip. Side view | Do not cut the PCB!
13 LED strip manual | liniLED® Top Power Colour
1
2
2
Take into account the direction of the arrow on the bottom of the
liniLED® LED strip and allign it with the arrow on the clamp (4).
4
Side view | Slide the clamp
(4)
connector (3).
6
Front view | Make sure the connector and the PCB are perfectly
horizontally alligned.
over the cable to reveal the