Table of Contents
Advertisement
All Safety Shields, Guards and Safety devices including (but not limited to) - the Chain
Shield, Cross Shaft Shield, Gearbox Shields, and PTO integral shields must be used and
maintained in good working condition. All safety devices should be inspected carefully at
least daily for missing or broken components. Missing, broken, or worn items must be
replaced at once to reduce the possibility of injury or death from entanglement.
DO NOT weld or repair rotating Blower components. Welds and other repairs may cause
severe vibration and/or component failure resulting in parts being thrown from the blower
causing serious bodily injury. See your Authorized Dealer for proper repairs.
Ensure any remote starting system is inoperative before servicing or cleaning the machine.
Inadvertent engine start up could result in entanglement or runover causing serious injuries
or death.
Use only OEM specified shear pins as replacement pins. The use of incorrect shear pins
can cause failures in the Snow Blower rotating components resulting in property damage
and/or serious bodily injuries.
All Safety Shields, Guards and other Protective Safety devices should be used and
maintained in good working condition. All safety devices should be inspected carefully at
least daily for missing or broken components. NEVER REMOVE PROTECTIVE SHIELDS
AND GUARDS!
When shields or guards are removed to access areas for maintenance, they must be
replaced and be in good condition before operating. Missing, broken, or worn shields,
guards, and other protective devices must be replaced at once and prior to operation to
reduce the possibility of injury or death from thrown objects, entanglement, or contact.
Cancer and Reproductive Harm www.P65Warnings.ca.gov.
RDX-117 06/20
© 2020 Alamo Group Inc.
SAFETY
(SSB-17)
(SSB-19)
NEVER MODIFY OR CUT PROTECTIVE SHIELDS OR GUARDS!
Safety Section 1-14
(SSB-9)
(SSB-14)
(SWS-2)
Advertisement
Table of Contents
