Maintenance And Service Safety Instructions And Practices - Schulte RDX-117 Operator's Manual

MAINTENANCE AND SERVICE SAFETY INSTRUCTIONS AND
PRACTICES
Make sure the PTO shield, integral driveline shields, and input shields
are installed when using PTO-driven equipment.
shield if it is damaged or missing.
Relieve hydraulic pressure prior to doing any maintenance or repair work
on the Implement.
blocked up, disengage the PTO, and turn off the tractor engine. Push
and pull the Remote Cylinder lever in and out several times prior to
starting any maintenance or repair work.
Always maintain the safety signs in good readable condition. If the safety signs are missing,
damaged, or unreadable, obtain and install replacement safety signs immediately.
Do not modify or alter this Implement.
Implement, any of its components or any Implement function.
Never work under the Implement, the framework, or any lifted
component unless the Implement is securely supported or blocked up
to prevent sudden or inadvertent falling which could cause serious
injury or even death.
Never attempt to lubricate, adjust, or remove material from the Implement while it is in
motion or while tractor engine is running.
Periodically inspect all moving parts for wear and replace when
necessary with authorized service parts. Look for loose fasteners, worn
or broken parts, and leaky or loose fittings. Make sure all pins have
cotter pins and washers. Serious injury may occur from not maintaining
this machine in good working order.
RDX-117 06/20
© 2020 Alamo Group Inc.
SAFETY
(S3PT-8)
Place the Implement on the ground or securely
(S3PT-09)
Do not permit anyone to modify or alter this
(SG-14)
(SG-20)
(SG-21)
Safety Section 1-12
Always replace any
(SG-8)
(SG-5)