Power Connector - HP 245 G8 Maintenance And Service Manual

Before removing the speakers, follow these steps:
1. Prepare the computer for disassembly
2. Remove the rubber feet (see
3. Remove the bottom cover (see
4. Remove the battery (see
To remove the speakers:
1. Disconnect the speaker cable from the system board (1).
2. Remove the tape (2) securing the cable.
3. Lift the speakers out of the computer (3).
Reverse this procedure to install the speakers.

Power connector

To remove the power connector, use this procedure and illustration.
Table 5-10 Power connector description and part number
Description
Power connector
Before removing the power connector, follow these steps:
1. Prepare the computer for disassembly
2. Remove the rubber feet (see
(Preparation for disassembly on page
Computer feet on page
Bottom cover on page
Battery on page 28).
(Preparation for disassembly on page
Computer feet on page
26).
27).
26).
Component replacement procedures
26).
Spare part number
L23188-001
26).
37