Table of Contents
Advertisement
Preparing
Various Setting Methods
Warning
•
A special method of installation is required when suspending the projector from a ceiling (ceiling mount). If
it is not installed correctly, it could fall, causing an accident and injury.
•
Failure to install the ceiling mount and projector may cause the projector to fall. Be sure to use the specific
Epson mount that supports this projector, and secure it to all of the projector's ceiling mount fixing points.
Also, make sure you secure the projector and the mount using wire and so on that is strong enough to hold
their weight.
•
Do not apply adhesives, oils, lubricants, detergents, solvents, chemicals, and so on to the projector case or
the mount. Otherwise, the projector case may deteriorate or be damaged causing the projector to fall from
the mount.
•
Do not set up the projector in locations exposed to humidity or dust, or in locations exposed to oil smoke or
steam such as on a kitchen counter, in the kitchen, or near a humidifier. Doing so could cause fire or electric
shock. In addition, the oil content could cause the projector's outer case to deteriorate and could cause the
projector to fall off from the ceiling where it is suspended.
Examples of environments that could cause the projector to fall due to case deterioration/damage
• Locations subject to oily smoke, such as factories, restaurant kitchens, or home kitchens
• Locations containing volatile solvents or chemicals, such as factories or laboratories
• Locations where oil, detergents, chemicals, and so on could adhere to the projector such as factories, restaurant
kitchens, or home kitchens
• Locations in which aroma oils are often used, such as relaxation rooms
• Locations near devices that produce excessive smoke, airborne oil particles, or foam at events
•
Do not install in locations where salt damage could occur, or in locations subject to corrosive gas such as
sulphuric gas from hot springs. Otherwise, corrosion could cause the projector to fall. It could also cause the
projector to malfunction.
•
Do not install it on an unstable shelf or in a place out of load range. Otherwise, it could fall or topple causing
an accident and injury.
•
When installing the projector in a high position such as on a shelf, take measures against falling by using
wires or belts to ensure safety in an emergency such as an earthquake, and to prevent accidents. If it is not
installed correctly, it could fall causing an accident and injury.
•
Do not block the air intake vent and air exhaust vent of the projector. Blocking its air intake vent and air
exhaust vent may trap heat inside causing fire.
•
Do not use or store the projector in dusty or dirty locations. Doing so could cause the quality of the projected
image to deteriorate, or the air filter to become clogged with dust which can cause malfunctions or a fire to
occur.
Attention
•
Do not project under the following conditions. Doing so could cause a malfunction or accident to occur.
• Do not project by standing the projector vertically
• Do not project from above or below
• Do not project by tilting to the left or right
•
Clean the air filter once every three months. Clean it more often if the environment is particularly dusty.
p.70
s
14
Advertisement
Table of Contents
