Installing The Hood Latch - Toro Groundsmaster 3500-D Operator's Manual

4

Installing the Hood Latch

CE Machines Only
Parts needed for this procedure:
1 Hood-latch bracket
2 Rivet
1 Washer
1 Screw (1/4 x 2 inches)
1 Locknut (1/4 inch)
Procedure
1. Unhook the hood latch from the hood-latch
bracket.
2. Remove the 2 rivets securing the hood-latch
bracket to the hood
1. Hood-latch bracket
3. Remove the hood-latch bracket from the hood.
4. While aligning the mounting holes, position the
CE lock bracket and the hood-latch bracket onto
the hood (Figure
Note:
The lock bracket must be against the
hood. Do not remove the bolt and nut from the
lock-bracket arm.
(Figure 8).
Figure 8
2. Rivets
9).
1. CE lock bracket
5. Align the washers with the holes on the inside of
the hood.
6. Rivet the brackets and the washers to the hood
(Figure 9).
7. Hook the latch onto the hood-latch bracket
(Figure 10).
1. Hood latch
g012628
8. Install the bolt into the other arm of the
hood-latch bracket to lock the latch in position
(Figure 11). Tighten the bolt but do not tighten
the nut.
14
Figure 9
2. Bolt and nut
Figure 10
g012629
g012630