Toro Groundsmaster 3500-D Operator's Manual page 21

Figure 25
1. Seat-adjustment lever
Hour Meter
The hour meter records the number of hours that
you operate the machine with the key switch in the
R position. Use these times for scheduling regular
UN
maintenance.
Engine-Coolant-Temperature
Warning Light
The temperature warning light glows if the engine
coolant temperature is too high. If the coolant
temperature rises another 10°, the engine shuts off
(Figure 24).
Glow-Plug-Indicator Light
The glow-plug-indicator light glows when the glow
plugs are operating (Figure
Oil-Pressure Warning Light
The oil-pressure warning light glows if the engine-oil
pressure drops below a safe level
oil pressure is low, shut off the engine and determine
the cause. Repair the engine-oil system before you
start the engine again.
Lift-Lock Lever
Use the lift-lock lever to secure the lift switch
24), to the -
RAISE DECK
2. Fuel gauge
24).
(Figure 24). If the
(Figure
position, when performing
maintenance on the cutting unit or when transporting
between mowing locations.
Mow/Transport Slide
Using your heel, move the mow/transport slide to the
left to transport, and to the right to mow
Note:
The cutting units operate only in the mow
position.
Important:
The mow speed is set at the factory
to 9.7 km/h (6 mph). You can increase or decrease
the mow speed by adjusting the speed-stop screw
(Figure 26).
g322579
1. Speed-stop screw
Indicator Slot
The indicator slot in the operator platform indicates
when the cutting units are in the center position
(Figure 23).
Throttle
Move the throttle forward to increase the engine
speed and rearward to decrease the engine speed
(Figure 24).
PTO Switch
The PTO switch has 2 positions: O
I (stop). Pull the PTO switch out to engage the
N
cutting-unit blades. Push the switch in to disengage
the cutting-unit blades
Cutting-Unit Shift Lever
To lower the cutting units to the ground, move the
cutting-unit shift lever forward. To raise the cutting
units, pull the shift lever rearward to the R
(Figure 24).
Note:
The cutting units do not drop unless the engine
is running.
Move the lever to the right or left to move the cutting
units in the same direction.
21
(Figure
Figure 26
(start) and
UT
(Figure 24).
AISE
23).
g031596
position