Product Overview; Controls - Toro Groundsmaster 3500-D Operator's Manual

Product Overview

Controls

Figure 23
1. Tilt-steering lever
2. Angle indicator
3. Reverse traction pedal
Figure 24
1. Throttle
2. Hour meter
3. Glow-plug-indicator light
4. Oil-pressure light
5. Check-engine light
6. Alternator light
4. Forward traction pedal
5. Mow/transport slide
6. Indicator slot
7. PTO switch
8. Cutting-unit shift lever
9. Key switch
10. Parking switch
11. Lift-lock lever
Traction Pedals
Press the forward traction pedal to move forward.
Press reverse traction pedal to move backward or to
assist in stopping when moving forward
Note:
Allow the pedal to move or move it to the
position to stop the machine.
NEUTRAL
Tilt-Steering Lever
Pull the tilt-steering lever back to tilt the steering wheel
to the desired position, then push the lever forward to
tighten (Figure
Parking Brake
Whenever you shut off the engine, engage the parking
brake to prevent accidental movement of the machine.
To engage the parking brake, pull up on the lever
(Figure 24).
Note:
The engine shuts off when you press the
traction pedal with the parking brake engaged.
g031595
Key Switch
The key switch is used to start, stop, and preheat
the engine. The ignition switch has 3 positions:
O , O /P
FF N REHEAT
O /P position until the glow-plug-indicator light
N REHEAT
goes out (approximately 7 seconds); then rotate the
key to the S
TART
Release the key when the engine starts
To shut off the engine, rotate the key to the O
position.
Note:
Remove the key from the switch to prevent
accidental starting.
Seat-Adjustment Lever
Move the seat-adjustment lever under the seat to the
g021539
left, slide the seat to the desired position, and move
the lever to the right to lock the seat into position
(Figure 25).
Fuel Gauge
The fuel gauge registers the amount of fuel in the tank
(Figure 25).
20
23).
, and S . Rotate the key to the
TART
position to engage the starter motor.
(Figure 23).
(Figure 24).
FF