Display Unit System Error - Sony CLX101ASA Service Manual

3-2-7. Display Unit System Error

Is the following connection/
communication error code
displayed on the Display Control
Software?
130
Yes
Is the following connection/
communication error code
displayed on the Color Uniformity
Alignment Software?
( 1)
Yes
Check the connection of the
harness between the cell and
signal board and between the
( 3)
UC-1 board and TM-62 board,
and then connect it correctly or
replace it.
Check points:
Flexible Flat Cable (FFC)
terminal surface is not broken.
FFC is connected correctly.
(not skew insertion)
Connector pin is not bent.
End
3-8 (E)
No
No
Replace the UC-1 board.
(The reading/writing of the
data is also necessary. ( 2) )
No
Is the symptom improved?
Yes
End
( 1):
For the details on how to read the error code, refer to the "3-3-4. Error Code List".
( 2):
Refer to the Manual for Color Uniformity Alignment Software, Section 3-3.
( 3):
UC-1 board or UP-13 board
Is the following UC error
No
code displayed on the
Display Control Software?
102, 121
Yes
Replace the UP-13 board.
Yes
Is the symptom improved?
No
End
Replace the UC-1 board.
(The reading/writing of the
data is also necessary. )
( 2)
End
The following error code is
displayed on the Display
Control Software.
104
Replace the PS-903 board.
Yes
Is the symptom improved?
No
End
Replace the UP-13 board.
End
CLX101ASA