Concept2 IDV 2760WH Manual page 51

EN
• The sensors do not respond to matte, dark colours (do not use black gloves). Do not place anything on the control
panel of the heating plate.
• Make sure the unit is prevented from being accidentally switched on, e.g. by a pet.
• When the heating plate is disconnected from the mains, the set parameters are reset.
• In monophase connection (see Connection of the terminal box) all the hotzones cannot be used at maximum power.
To prevent power overload of the respective circuit breaker, the unit automatically reduces the input of individual
hotzones.
Before first use
Prior to the start of use of a new unit, wipe it with a wet and then a dry cloth.
Switching on the heating plate
To switch on the heating plate, press the ON/OFF symbol (1). If you do not make a further selection within 1 minute, the
heating plate automatically switches off.
Switching on a hotzone
1. Press the symbol for hotzone selection (7) to activate the hotzone. „ 0" symbol is blinking for the selected hotzone on
the display (3).
2. Set the required power level by pressing or moving your finger over the values from 1 to 9 on the slider (2).
Note: If the „ U" symbol is shining on the display (3), the cooking utensil's bottom diameter is too small or it is made of
an unsuitable material. Use a smaller hotzone or utensil with a larger bottom diameter or a utensil made of another
material.
Switching off a hotzone
1. Press the symbol for hotzone selection (7) to activate the hotzone (number of the selected hotzone is blinking).
2. Set the power level to „ 0" by pressing or moving your finger over the slider (2).
3. After the hotzone has been switched off, its display may show the „ H" symbol indicating that the zone is hot and there
is a risk of burning. This residual heat can be utilised.
Child lock function
This function prevents unwanted operation of the heating plate. Procedure:
a) Locking
Press the symbol for activation/deactivation of the child lock (6). The „Lo" symbol (locked) will be illuminated on the
display (3). Thus the control panel of the heating plate is locked except for the ON/OFF symbol (1).
b) Unlocking
e
Press and hold the symbol for activation/deactivation of the child lock (6) until a beep is heard. „ Lo" symbol will go off.
-
Hotzone delayed OFF function
1. Press the symbol for hotzone selection (7) to activate the hotzone. The power level is displayed on the respective
display of the hotzone.
e
2. PPress the symbol of setting of the delayed OFF timer (5). Press or move your finger over the slider to set the delayed
d
switch-off time of the respective hotzone (1-99 minutes).
3. The delayed OFF function starts in several seconds (the remaining time is shining on the timer display and the
h
indicator of the selected hotzone is blinking).
e
4. After the set time elapses, a sound signal is heard.
Note: The delayed OFF function can be set for one selected hotzone only. To deactivate the delayed OFF function, set
the timer to the "00" value. If you switch off the hotzone manually before the delayed OFF time elapses, the setting of
the delayed OFF timer is reset.
p
0
IDV2760
IDV 2760WH | IDV 2760
EN
49
51