Electrical Safety - GLP Fusion EXO Beam 10 User Manual

www.glp.de
companies will take no responsibility for damage or injury resulting from disregard for
the information in the user documentation.
● Check the GLP website at www.glp.de and make sure that you have the latest
version of this manual. Check the fixture software version indicated on page 2 of this
manual and then use the fixture's control panel to check the version installed in the
fixture. If the versions are not the same, this manual may still cover the fixture,
because software updates do not always affect the way you use the fixture.
However, it is possible that this manual does not match the fixture perfectly.
Software release notes can help clarify this question. You can consult software
release notes and download the correct version of this manual on the GLP website if
necessary.
● Make all user documentation available to all installers and operators. Save this
document for future reference.
● If you have any questions about the safe operation of the fixture, please contact an
authorized GLP distributor (see list of distributors at www.glp.de).
● Use the fixture only as directed in this manual. Observe all markings in this manual
and on the fixture.
● Refer all repairs and any service operation not described in this manual to a
technician authorized by GLP.
● The light source in this fixture must not be changed by the end user.
● Read and follow the user documentation for all additional equipment.

Electrical safety

● Do not allow the fixture to become immersed. Do not expose the fixture to high-
pressure water projections.
● Keep any unused connectors on the fixture sealed with their protective caps at all
times, both when the fixture is in use and when not in use.
● Use only a source of AC mains power that complies with local building and
electrical codes and has both overload and ground fault (earth fault) protection.
● Ensure that the fixture is electrically connected to ground (earth).
● Disconnect the fixture from AC mains power before carrying out any installation or
maintenance work and when the fixture is not in use.
● Disconnect the fixture from power immediately if any seal, cover, cable, connector
or other component is damaged, defective, deformed or showing signs of
overheating. Do not reapply power until the fixture has been repaired and made
safe by a technician authorized by GLP.
● Check that all power distribution equipment, cables and connectors are in perfect
condition, rated for the electrical requirements of all connected devices, suitable
for their application and suitable for the installation environment.
6
Safety
EXO Beam 10 User Manual Rev. A