Led Explanation; Port And Button Description - TP-Link RE200 User Manual

Chapter 1
1 2 1

LED Explanation

You can check the extender's working status by following the LED Explanation table.
Name
5GHz
2.4GHz
(Signal)
(Ethernet)
(Power)
(WPS)
1 2 2

Port and Button Description

Port/Button
(WPS Button)
RESET Button
Ethernet Port
Status
The extender is connected or not connected to the 5GHz
On/Off
wireless network of your host router.
The extender is connected or not connected to the
On/Off
2.4GHz wireless network of your host router.
The extender is connected to your router's wireless
Solid green
network and is in a suitable location.
The extender is experiencing poor signal strength. Try
Solid red
relocating it closer to your host router.
Off No wireless connection is established.
The Ethernet port is connected or not connected to a
On/Off
powered-on device.
On/Off The extender is on or off.
Blinking The system is starting up or firmware is being upgraded.
On WPS connection is established.
Blinking WPS connection is in progress.
WPS connection has been established for more than 5
Off
minutes or WPS connection failed.
Press the WPS button on your host router, and immediately press
the extender for 1 second. The
from blinking to solid on, indicating successful WPS connection.
Use a pin to press the button for 1 second to reset the extender.
Connect your device to the Ethernet port of the extender via an
Ethernet cable to join the Wi-Fi network.
Get to Know About Your Extender
Indication
Description
LED of the extender should change
on
4