Change Lan Settings; Specify Dhcp Server Settings - TP-Link RE200 User Manual

Chapter 5
5 3

Change LAN Settings

The extender is preset with a default LAN IP 192.168.0.254, with which you can log in to
the web management page. The LAN IP address, together with the Subnet Mask, also
defines the subnet that the connected devices are on. If the IP address conflicts with
another device on your local network or your network requires a specific IP subnet, you
can change it.
1. Visit http://tplinkrepeater.net, and log in with your TP-Link ID or the password you set
for the extender.
2. Go to Settings > Network
3. Select Use the following IP
4. Enter a new IP Address
5. Enter the gateway that is in the same subnet as the
the LAN IP address of your extender.
6. Leave the primary and secondary DNS addresses as the default settings.
7. Click SAVE.
5 4

Specify DHCP Server Settings

By default, the DHCP (Dynamic Host Configuration Protocol) Server is auto and the
extender acts as a DHCP server and dynamically assigns TCP/IP parameters to client
devices from the IP Address Pool when the router's DHCP server is disabled. You can
change the settings of the DHCP Server if
necessary.
1. Visit http://tplinkrepeater.net, and log in with your TP-Link ID or the password you set
for the extender.
> LAN Settings.
address.
as needed, and leave the subnet mask as the default settings.
Customize Your Network
IP Address. The gateway is usually
30