Removing A Card Or Blank - Dell Precision M4300 User Manual

The computer recognizes most cards and automatically loads the appropriate device driver. If the
configuration program tells you to load the manufacturer's drivers, use the floppy disk or CD that came
with the card.
If you have an adapter, such as the one shown below, you can use 34-mm ExpressCards in the PC Card
slot. For information about using the PC Card slot, see "PC Card" on page 59.

Removing a Card or Blank

CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions in your
Information Guide
.
NOTICE:
Click the
the computer. If you do not stop the card in the configuration utility, you could lose data. Do not attempt to eject a
card by pulling its cable, if one is attached.
Press the latch and remove the card or blank. For some latches, you must press the latch twice: once to
pop the latch out, and then a second time to pop the card out.
icon (in the taskbar) to select a card and stop it from functioning before you remove it from
Product
61
Using Cards