Commonly Used Settings; Changing The Boot Sequence - Dell Precision M4300 User Manual

Dell precision m4300: users guide
Hide thumbs Also See for Precision M4300:
Table of Contents

Advertisement

In the system setup program, primary categories of settings are listed on the left. To view the types of
settings in a category, highlight the category and press <Enter>. When you highlight a setting type, the
right side of the screen displays the value for that setting type. You can change settings that appear as
white type on the screen. Values that you cannot change (because they are determined by the computer)
appear less bright.
System-setup key functions are listed across the bottom of the screen.

Commonly Used Settings

Certain settings require that you reboot the computer for new settings to take effect.

Changing the Boot Sequence

The boot sequence tells the computer where to look to find the software needed to start the operating
system. You can control the boot sequence and enable/disable devices using the Boot Sequence page,
which is located in the System category.
NOTE:
To change the boot sequence on a one-time-only basis, see "Performing a One-Time Boot" on page 90.
The Boot Sequence page displays a general list of the bootable devices that may be installed in your
computer, including but not limited to the following:
Diskette Drive
Modular bay HDD
Internal HDD
CD/DVD/CD-RW drive
During the boot routine, the computer starts at the top of the list and scans each enabled device for the
operating system start-up files. When the computer finds the files, it stops searching and starts the
operating system.
To control the boot devices, select (highlight) a device by pressing the down-arrow or up-arrow key, and
then enable or disable the device or change its order in the list.
To enable or disable a device, highlight the item and press the space bar. Enabled items appear as white
and display a small triangle to the left; disabled items appear blue or dimmed without a triangle.
To reorder a device in the list, highlight the device and then press <u> or <d> (not case-sensitive) to
move the highlighted device up or down.
Boot sequence changes take effect as soon as you save the changes and exit the system setup program.
Performing a One-Time Boot
You can set a one-time-only boot sequence without entering the system setup program. (You can also use
this procedure to boot the Dell Diagnostics on the diagnostics utility partition on your hard drive.)
1 Shut down the computer through the Start menu.
90
System Setup Program

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Precision tx453

Table of Contents