Why Run A Ram Test; Subtests; System Set Test Group; Why Run A System Set Test - Dell Latitude CP Reference And Troubleshooting Manual

Switch Description
–r number Repeats the subtest this number of times. Valid numbers are 1 through 9999. A value of 0 causes the
test to run until you press <Ctrl><Break>. The default value is 1.
–m number Stops the test if this number of errors occur. Valid numbers are 1 through 9999. A value of 0 causes
the test to accept an unlimited number of errors. The default value is 0.
–s hexadecimal Starts the test at this hexadecimal address. Valid hexadecimal values are 0 up to the highest memory
memory address address. The default value is 0.
–e hexadecimal Stops the test at this hexadecimal address. Valid hexadecimal values are 0 up to the highest memory
memory address address. The default is the highest memory address.
–o[f filename,p] Outputs the test report to a file (f) or a printer (p). If you output to a file, append the filename after
the f parameter. If you do not specify a filename when using the f parameter, the test report is output
to a file named result. If you output to the printer, the test file is output to LPT1.
–[q,c] Runs the quick (q) or comprehensive (c) subtest. The comprehensive subtest is the default value.
–np Does not pause when an error occurs or a subtest finishes. Pause (p) is the default value.

Why Run a RAM Test?

Faulty memory can cause a variety of problems that may
not, at first glance, appear to be happening in RAM. If the
computer is displaying one or more of the following
symptoms, run both the subtests in the RAM test group to
verify that the memory is not at fault:
•
A program is not running as usual, or a proven piece
of software appears to malfunction and you confirm
that the software itself is not at fault. (You can con-
firm that the software is functioning properly by
moving it to another computer and running it there.)
•
The computer periodically locks up (becomes un-
usable and must be rebooted), especially at different
places and times in different programs.

Subtests

Three subtests are available for the RAM test group: the
Quick Test, the Comprehensive Test, and the Secondary
Cache Test. The Quick Test performs an address check to
determine whether the computer is properly setting and
clearing individual bits in RAM, and whether the RAM
read and write operations are affecting more than one
memory address location at a time. This subtest checks
all available RAM, including the secondary cache. The

Table 4-3. RAM Test Switches

Comprehensive Test also performs an address check, as
well as the following:
•
•
•
S
The subtests in the System Set test group check the com-
puter's basic system board components and verify their
related functions.

Why Run a System Set Test?

The System Set subtests double-check many system
board components, such as the computer's I/O circuitry, that
are tested by other test groups or subtests in the diagnostics.
You should run the System Set test group if you are having a
Data pattern checks, to look for RAM bits that are
stuck high or low, short-circuited data lines, and
some data pattern problems that are internal to the
memory chips
A parity check that verifies the ability of the memory
subsystem to detect errors
A refresh check, to verify that the dynamic RAM
(DRAM) is being recharged properly
ystem Set Test Group
Running the Dell Diagnostics 4-13