Table of Contents
Advertisement
To use your NBG7815 as a bridge, go to Settings > System > Operating Mode and select Bridge Mode.
2
Figure 17 Changing to Bridge mode
Note: You have to log in to the Web Configurator again when you change modes. As soon as
you do, your NBG7815 is already in Bridge mode.
When you select Bridge Mode, the following pop-up message window appears.
3
Figure 18 Pop up for Bridge mode
Click OK. Then click Apply. The Web Configurator refreshes once the change to Bridge mode is
successful.
6.3.1 Accessing the Web Configurator in Bridge Mode
Log in to the Web Configurator in Bridge mode, do the following:
Log into the Web Configurator. See the Quick Start Guide for instructions on how to do this.
1
Connect your computer to one of the LAN port of the NBG7815.
2
Connect a modem/router to the other LAN port of the NBG7815 using an Ethernet cable.
3
If the NBG7815 is not connected to a router or DHCP server, the NBG7815 cannot assign your computer
4
an IP address.
After you've set your computer's IP address, open a web browser such as Internet Explorer and type
5
"http://(DHCP-assigned IP) as the web address in your web browser.
Chapter 6 Bridge Mode
NBG7815 User's Guide
41
Advertisement
Table of Contents
