ZyXEL Communications ARMOR G5 User Manual page 16

Select a position free of obstructions on a wall strong enough to hold the weight of the device.
1
Mark two holes on the wall at the appropriate distance apart for the screws.
2
Be careful to avoid damaging pipes or cables located inside the wall when
drilling holes for the screws.
If using screw anchors, drill two holes for the screw anchors into the wall. Push the anchors into the full
3
depth of the holes, then insert the screws into the anchors. Do not insert the screws all the way in - leave
a small gap of about 0.5 cm.
If not using screw anchors, use a screwdriver to insert the screws into the wall. Do not insert the screws all
the way in - leave a gap of about 0.5 cm.
Make sure the screws are fastened well enough to hold the weight of the NBG7815 with the connection
4
cables.
Remove the rubber feet.
5
Align the holes on the back of the NBG7815 with the screws on the wall. Hang the NBG7815 on the
6
screws.
Figure 7 Wall Mounting- Rubber Feet
Chapter 1 Introduction
NBG7815 User's Guide
16