Handle And Throttle Trigger - Husqvarna 131R Workshop Manual

6. If no spark occurs, examine the spark plug
connection. Remove the spark plug cover and make
sure that the ignition cable is not damaged. If it is
necessary, remove a part of the cable to get
sufficient connection at the connection coil.
7. Use pliers to make a new hole in the ignition cable to
attach the connection coil.
8. Attach the ignition coil to the ignition cable and make
sure that the wire is folded along the cable. Move
the connection coil into the spark plug cover. If it is
necessary, lubricate the hole in the spark plug cover.
9. If no spark occurs, examine the other cables for
unsatisfactory connections, dirt, corrosion, cable
breakage and damaged insulation. If no spark
occurs, replace the ignition module.
Note: Use an Ohmmeter to examine if a cable is
defective.
28 - Repair instructions

8.5 Handle and throttle trigger

8.5.1 To disassemble the handle
1. Remove the 4 screws, the bolt and the nut.
2. Remove the handles halves from the rod. Make sure
that the parts do not fall to the ground.
3. Remove the throttle trigger (A). Remove the throttle
wire (B). Remove the spring (C). Remove the throttle
lock (D).
4. Remove the stop switch.
D
B
C
A
675 - 002 - 23.04.2018