Throttle - Husqvarna 326R Workshop Manual

Fuel system

Throttle

Separate the engine body and the
clutch cover.
Pull away the shaft with the throttle
from the clutch cover.
Remove the throttle from the shaft.
A
Throttle
We recommend that the throttle is
dismantled from the engine and shaft in
order to efficiently carry out service and
repair work.
Separate the engine body and the
clutch cover (see chapter "Ignition
system").
Remove both screws (A) (one on each
side).
Remove the screws (B) and pull away
the shaft with the throttle from the
clutch cover.
Loosen the 3 front screws (C) (approx.
2 turns) holding the throttle halves and
pull the throttle off of the shaft.
Remove the screws holding the throttle
together and carefully separate the
halves.
Note how the different parts are fitted.
Pay special attention to which way the
return spring (A) faces.
The stop contacts can be pried back
using a small screwdriver if they need
to be replaced.
3
23