Husqvarna 131R Workshop Manual page 34

8.9.2 Overview of the carburetor on 967 84 31-xx and 967 84 30-xx
A
A. Sealing ring
B. Gasket
C. Diaphragm
D. Screen
E. Fuel inlet
F. Valve, inlet
G. Gasket
H. Diaphragm
I. Pump
34 - Repair instructions
B
C
8.9.3 To assemble the carburetor
Overview of the carburetor on 967 84 31-xx and
See
967 84 30-xx on page 34 for an overview of how the
parts of the carburetor connects.
1. Assemble the carburetor in the opposite sequence
to how it was disassembled. Make sure that the
sealing ring has its wide edge against the carburetor
housing. Make sure that the screen is clean and not
damaged.
2. Do a pressure test of the carburetor:
a) Make sure that the carburetor is sealed.
b) Connect a pressure tester to the fuel inlet on the
carburetor. Refer to
c) Pump up the pressure to 0.5 bar.
D
E
F
G
H
I
Servicing tools on page 16 .
675 - 002 - 23.04.2018