Master Spas SEATTLE Owner's Manual & Limited Warranty page 37

REGULAR MAINTENANCE PROCEDURES
WATCH HOW-TO VIDEOS:
NOTE: These maintenance procedures are the responsibility of the spa owner to perform. These
procedures are not covered by the spa warranty.
CARE OF YOUR SPA COVER
Always cover your spa when not in use with an approved insulating spa cover by Master Spas.
Keep the spa cover on to minimize heat loss during heating of the spa between uses (but not
while it is being used). This will greatly reduce energy consumption and will cause spa water to
heat more rapidly. Water loss and chemical usage will also be reduced.
• Ensure the cover is fitted tightly, as per manufacturer's instructions to maximize insulation.
• Be sure to lock down all straps on the cover after each use.
• Do not allow spa to sit uncovered in direct sunlight. The heat and UV from direct sun exposure
can cause damage to exposed shell surfaces of the spa as well as damage or discoloration of the
spa controls and fittings.
• See cover manual instructions for detailed instructions on proper cover care. Clean the cover at
least once a month using mild soap and water. Rinse thoroughly with fresh water to remove
pollutants and soap residue. If mold/mildew staining has occurred (particularly on bottom of the
cover), a mixture of bleach and water used with a soft cloth may be necessary. Thoroughly rinse
with fresh water after cleaning.
• Keep cover open for 15 minutes after adding chemicals to prevent excessive off gas buildup and
damage.
• When the spa is being used, the cover should be placed in a clean, dry area, otherwise it can pick
up dirt and bacteria. Covers should not be put on wooden tables or wooden decking because of
the risk of bleaching the wood.
• The use of a cover lift accessory or other device ensures the cover will not come into contact with
the ground and retains its cleanliness (particularly the surface in close proximity to the spa water
surface). The cover should be stored in an appropriate location, where it cannot be damaged, or
cause damage.
NOTE: If your spa is going to be left empty for prolonged periods, do not place cover directly on the
spa's surface (closed and sealed). Instead, place a 1" block of high density foam between the
cover and the spa. This allows for ventilation to help reduce mold and mildew from occurring
while the spa is empty.
NOTE: The cover warranty is not part of the limited warranty provided with the spa. It is provided
through the cover manufacturer and may not be through Master Spas. Check the tags
and labeling on your cover to verify manufacturer and refer to the manufacturer's care,
maintenance and warranty information. Your dealer can help provide you with these
details.
NOTE: Always use the water feature controls to turn down the water flow so that the water features
do not hit the cover when the cover is closed. Do not turn them all the way off.
CARE OF YOUR OZONE SYSTEM
The ozone hose and check valve connecting between the ozone generator and ozone injector
should be inspected and/or replaced, if necessary, every 12 months. Depending on conditions
of the air which is being brought in to the ozone generator, the ozone hose and check valve
can wear more rapidly. This regular maintenance is not covered under the spa warranty. We
recommend that your Master Spas Dealer or service organization be contacted to perform this type
of maintenance.
DO NOT DIVE. DO NOT DIVE.
masterspas.com/video-tutorials
106 35