Siemens EX8 LX6 Series Instruction Manual page 60

Trouble shooting
en
Display
The cooking sensor indicator
does not light up.
The indicator on the sensor
flashes twice.
The indicator on the sensor
flashes three times.
"Š‹‹‹
"Š‹‚‹
—...‹‹
š"
Do not place hot cookware on the control panel.
Notes
If " appears on the display, press and hold the
■
button for the relevant cooking zone in order to read
the fault code.
If the fault code is not listed in the table, disconnect
■
the hob from the mains power supply and wait
30 seconds before reconnecting it. If this code is
displayed again, contact the technical after-sales
service and specify which fault code has appeared.
If a fault occurs, the appliance will not switch to
■
standby mode.
60
Possible cause
The cooking sensor is not responding and the
indicator does not light up.
The battery in the cooking sensor is almost flat.
You may be interrupted the next time you cook
by the battery running out.
The connection to the cooking sensor has been
broken.
The operating voltage is incorrect and outside of
the normal operating range.
The hob is not connected correctly.
Demo mode is activated.
Solution
Replace the 3 V CR2032 battery. For more information, see the
section entitled ~ "Changing the battery".
If this does not solve the problem, press and hold the symbol on
the cooking sensor for 8–10 seconds and then reconnect the
cooking sensor to the hob. For more information, see the section
entitled ~ "Connecting the wireless temperature sensor to the
control panel".
If the problem persists, contact our technical after-sales service.
Replace the 3 V CR2032 battery. For more information, see the
section entitled ~ "Changing the battery".
Press and hold the symbol on the cooking sensor for 8–10 sec-
onds and then reconnect the cooking sensor to the hob. For more
information, see the section entitled ~ "Connecting the wireless
temperature sensor to the control panel".
Contact your electricity supplier.
Disconnect the hob from the mains. Ensure that the hob has been
connected as shown in the circuit diagram.
Disconnect the hob from the mains. Wait for 30 seconds before
reconnecting it. Touch any sensor in the next three minutes.
Demo mode has now been deactivated.