Mounting - Lenze MCA Series Mounting And Switch-On Instructions

Mechanical installation

Mounting

Mounting
Transmission elements
Fit or remove transmission elements only using suitable equipment.
•
For fitting the transmission elements use the center hole in the shaft.
•
Avoid impacts and shocks.
•
In case of a belt drive, tension the belt in a controlled manner according to manufacturer
•
information.
Be sure to carry out mounting in a manner free from distortion.
•
Compensate minor inaccuracies by suitable flexible couplings.
•
Fastening
Use screws with a minimum property class of 8.8.
•
Observe prescribed tightening torques.
•
Secure against unintended loosening.
•
For alternating loads, we recommend applying anaerobic curing adhesive between flange
•
and mounting surface.
56