Walker Edison BR4DDR Assembly Instructions Manual
Hide thumbs
Also See for BR4DDR:
- Assembly instructions manual (11 pages) ,
- Assembly instructions manual (11 pages)
Advertisement
Quick Links
Advertisement
Related Manuals for Walker Edison BR4DDR
Summary of Contents for Walker Edison BR4DDR
- Page 1 BR4DDR Assembly Instructions Keep these instructions for future reference. Revised 05/2018...
- Page 3 02 pcs Right foot Top panel 01 pcs 02 pcs Right side panel Left foot 01 pcs 02 pcs Left side panel Front drawer 04 pcs 01 pcs Bottom front crossbeam Left side drawer 01 pcs 04 pcs Back crossbeam Right side drawer 02 pcs 04 pcs...
- Page 4 Ø8*30mm Wooden dowel Ø3,0*14mm Screw Ø6,0*10mm Screw Screw Ø4,0*30mm M4*22mm Screw Ø4,5*45mm Screw Ø10*10 Nail 300mm Right Slide 300mm Left Slide Knob Glue 808 mm “H” Profile Wall anchor Washer Ø6mm Hammer recommended for assembly (not included)
- Page 5 Step 1 Please assemble on a clean soft surface to avoid damage. Glue tube Ø8*30mm Step 2 Please assemble on a clean soft surface to avoid damage. Pre-Drilled holes Ø6,0*10mm The wheel to The wheel to the Front the Front Right slide 300mm Left slide 300mm...
- Page 6 Step 3 Glue tube Ø4,0*30mm Step 4 Glue tube Ø4,0*30mm...
- Page 7 Step 5 Ø4,0*30mm Step 6 Apply glue to leg contact surfaces 1º 2º Ø4,5*45mm Glue tube...
- Page 8 Step 7 Ø10*10 Step 8 The wheel to the Back Bottom M4x22mm Left slide 350mm Ø3,0*14mm Right slide 350mm Ø4,0*30mm...
- Page 9 Step 9 To adjust the drawer front position: Loosen the screw (part C) you used to install the drawer runner (either parts H or I) in step 2, to the side panel (parts 02 or 03), depending on the side (left or right), as shown.
-
Page 10: Back Panel
Wall anchor and hardware are included with this product. Please make sure hardware is suitable for your walls before installing, as different wall materials may require different types of anchors. 1º 2º Wall Back panel Ø6mm Ø4,0*30mm P.10...