Features And Equipment - Indexa DF25A Operating Instructions Manual

Operating instructions
GB
1. Introduction
Read through these operating instructions fully and carefully and while doing
so fold out page 3 with the illustrations. The operating instructions belong to
this product and contain important points concerning bringing the appliance
into service and its operation.
Always pay attention to all safety instructions. Should you have any questions
or be unsure about operating the appliance ask a specialist. Keep these
instructions in a safe place and should the need arise pass them on to a third
party.
2. Proper use
The digital wireless camera set consists of the camera DF20K and monitor
DF25AM with two mains adaptors.
It is to be used for the surveillance of rooms, entrance hallways, driveways etc.
through video pictures and sound. The video and audio transmission is wireless
using a frequency of 2.4GHz.
The power is supplied through the supplied mains adapters connected to a
230VAC, 50Hz mains supply. The monitor has an inbuilt Lithium rechargeable
battery which is automatically recharged by the mains adapter.
If there is sufficient light a colour picture will be transmitted. At low ambient
light levels the integrated Infrared LEDs are automatically switched on. In this
case the immediate area (max. 3 m) will be illuminated and the video picture
switches to black and white mode for improved light sensitivity. Due to the
sensitivity to infrared light some colours may vary on the camera picture. If the
surveillance is specifically required in a dark environment, then additional
lighting should be installed.
Up to four wireless cameras DF20KA can be used with one monitor. The camera
channels can be manually selected or automatically displayed in sequence if
the scan mode is selected. The camera pictures can also be observed
simultaneously in quad-split screen mode.
Video and audio data of a single camera can be stored on a SD card if
necessary.
The wireless transmission is digital and on constantly changing frequencies
(frequency hopping) which are synchronised between the camera and the
monitor. Only the receiver which has been "paired" with the camera can receive
the synchronised signals. This security feature prevents access of the camera
signal by third parties.
The camera is weatherproof (Protection class IP66) and can be used not only
indoors but also for mounting outside. Wherever possible it should be protected
from direct rainfall. The receiver and both mains adapters are for indoor use
only and must be protected from moisture. The set is for use in private
households. A video surveillance system does not replace your duty of care or
supervision. Observe the regulations concerning video surveillance in
commercial and public areas.
Any other use or modification of the device is not authorised. No liability will be
accepted for consequential damages or for damages caused by improper use or
incorrect operation. No liability will be accepted for consequential damages
caused by any function or by malfunction. Unless any liability is specifically
required by law, claims for damages, in particular those for personal injury or
property damage caused by non-functioning or malfunctioning of the
machine, are excluded.
This appliance is not intended to be used by people (including children) with
restricted physical, sensory or mental capacities, or a lack of experience
and/or knowledge, unless they are supervised by, or receive instructions how
to use the appliance from a person responsible for their safety.
3. Package contents
!
DF20K camera with connection cable to mains adapter
!
Antenna
!
Monitor DF25AM
!
2x mains adapter 5VDC
!
Camera bracket with screws and plugs
!
User manual

4. Features and Equipment

Monitor DF25AM (s. fig. A)
1 Monitor
2 Antenna
3 Screen
4 Loudspeaker
5 Record button
6 Slot for SD-card
7 On/off button
8 Stand
9 Mains adapter
Camera DF20K (s. fig. B)
19 Camera
20 Power LED
21 Infrared LEDs
22 Connection-LED
23 Triangular nut
24 Wing screw
25 Bracket
26 Microphone
27 Antenna connection
Screen display (s. fig. C)
36 Reception indicator
37 Chanel indicator
38 Recording indicator
39 SD-card indicator:
SD
SD
40 Date
41 Time
Settings in OSD menu (s. fig. D)
42 Time Setup
43 Camera Setup
44 Pairing
(s. fig. A + B)
10 Battery LED
11 Power LED
12 Direction button
13 Menu button
14 Reset button (below antenna)
15 Microphone
16 OK button
17 Connection (no function)
18 Mains adapter connection
28 Pairing button
29 Mains adapter connection
30 Mains adapter
31 Lens
32 Daylightsensor
33 Antenna
34 Plugs
35 Screws
SD-card inserted SD-card locked
SD
SD-card full SD-card error
SD
GB - 21