Technical Data; Safety Instructions; Location Of Equipment - Indexa DF25A Operating Instructions Manual

45 Power-Saving
46 Factory Default
47 Scan Period
48 Playback
49 SD Card Format
50 Brightness

5. Technical data

System data
Radio-Frequency
Modulation
Radio range (max.)
Camera DF20K
Operating Voltage
Current consumption
Channels
Picture sensor
Viewing angle
Light sensitivity
Illumination
Illumination distance
Microphone
Protection class
Dimensions without antenna (mm) 92 x Ø 42
Operating temperature
Monitor DF25AM
Operating Voltage
Current consumption
Lithium rechargeable battery
Screen
Resolution (Pixel)
Frame rate
Recording format
storage medium
max. recording capacity in hours
loudspeaker
Protection class
Dimensions without antenna (mm) 130 x 90 x 27
Operating temperature
Mains Adapter
Operating Voltage
Output
22 - GB
2,4 GHz
GFSK
150 m (open space)
"
5 V DC (mains adapter)
340 mA
4
1/5" CMOS
approx. 39° horizontal
1-8 Lux (w/o IR-LEDs)
9 Infrared LEDs
max. 3 m
built in
IP 66
- 10° C to + 40° C
"
5 V DC (mains adapter)
700 mA
3,7 V, 1250 mA
3,5" (=8,8 cm) TFT-LCD
320 x 240 (QVGA)
max 18 fps
AVI
SD card (max. 32 GB)
4 (2 GB SD-card) / 17 (8 GB) /
34 (16 GB) / 70 (32 GB)
built in
IP 20
0° C to + 40° C
230 V ~ 50 Hz
"
5 V , 1,0 A

6. Safety instructions

The following instructions are provided for your safety and satisfaction during
operation of the device. Note that non-observance of these safety instructions
results in significant risks of accident.
Danger! If this point is not heeded life and health is endangered.
!
Do not leave small children unsupervised with the device, packaging
material or small parts. Otherwise there is a risk of fatal injury due to
choking or suffocation.
!
Do not damage any gas, electricity, water or telecommunication lines
during drilling and fixing work. Otherwise there are dangers of fire,
personal and fatal injury.
!
Treat the cables carefully. Lay these so that they cannot be damaged and
do not present any tripping hazard. Otherwise there are dangers of fire,
personal and fatal injury.
!
If you use the device for monitoring babies or small children ensure that
the camera and cable are out of reach of children. Otherwise there is a
risk to life and limb!
!
Do not pull the cables over sharp edges and do not crush or crimp them
elsewhere. Otherwise there are dangers of fire, personal and fatal injury.
!
Prevent the device from coming into contact with moisture and do not
submerge in water. Otherwise there is a danger of fatal injury.
!
Only operate the device from the supplied power supply. Before
connecting the power supply to the mains, ensure that the mains current
complies with 230 V ~, 50 Hz and is fitted with a fuse according to
regulations. Otherwise there are dangers of fire and fatal injury.
Attention! Non-observance of these instructions puts property at risk
of damage.
!
Protect the equipment and the cables against strong magnetic or
electrical fields and against strong mechanical loads and vibrations.
!
Do not place the equipment near fire, heat or in areas of high
temperature.
!
Only use the equipment with the supplied original parts or original
accessories.
!
Do not connect any damaged device (e.g. damage in transit). Repairs to
the equipment must only be performed by specialists.
!
Remove the mains adapter from the mains outlet when the device is not
required for a longer time.

7. Location of equipment

Before mounting the camera check the wireless reception from the desired
location. Observe the following points:
!
Position the camera so that no direct light or sunshine falls on the lens
otherwise the picture may become overexposed. Remember that the
position of the sun changes. Check the camera image before mounting.
Provisionally connect and commission the device and hold the camera in
the desired position. If necessary, change the camera position until you
have found the desired view.
!
Select the distance between the camera and the subject according to the
level of detail desired.