Condenser Cleaning - Beverage-Air UCR Series Installation And Operating Instructions Manual

User Manual for UCR Refrigerators

CONDENSER CLEANING

Keeping the condenser coil clean is critical to efficient
operation.
The condenser coil is located right behind the back grille
of the cabinet. It should be inspected once a month and
cleaned as required. Vacuum clean all surfaces of the
condenser. Make sure no fins are bent or damaged in the
process. If there are bent fins, carefully straighten them
so that air can flow through the coils. Failure to keep
the condenser coil clean will lead to poor performance,
excessive power consumption and compressor failure
and may result in loss of property. Failure to keep the
condenser coil clean may void the limited warranty.
1. Unplug unit from power supply.
CAUTION
2. Remove the Phillips head screws at the top of the
panel.
3. Once the screws have been removed the you can lower
the panel.
Please note the electrical cord will still be connected to the
panel.
4. Examine condenser surface, if dusty, brush and
vacuum the dust and lint from the surface of the
coil. Brush up and down to avoid damaging the fins.
Use care to not disturb the wires connected to the
controller.
Note: If the coil is greasy, the coil will need to be cleaned
with coil cleaner and that should be left to an experienced
technician.
5. After the condenser is clean, return the grille panel to
Rev. 06/20
Rotating fan blade can cause
personal injury.
Unplug unit from power supply
before beginning to clean
condenser
the unit.
6. To reinstall the rear panel line up the bottom of the
panel to the bottom of the unit keeping the screw
holes lined up on the panel and on the unit.
7. Reinstall the Phillips head screw.
8. Note: Air filters are not recommended as they restrict
the flow of cooling air.
Condenser Surface
Beverage-Air
Beverage-Air
Remove These
Screws
Remove This Panel
15