Beverage Air 3779 Champion Blvd Winston-Salem, NC 27105 INSTALLATION AND OPERATION MANUAL VM2, VM7, VM12, VM18 Congratulations! You have just purchased the finest commercial refrigeration available. •••• www.beverage-air.com ••••...
We strongly recommend servicing be performed by a qualified individual. •••• www.beverage-air.com • Pg. 2 •••• WARNING! Do not allow children to climb, stand, or hang on the shelves in the refrigerator. They could damage the refrigerator and seriously injure themselves.
The unit is constructed to facilitate using a forklift to handle it. (Fig. 1) Use this handling means to move the equipment as close as possible to the location where it will be installed. IMPORTANT: Never push, pull or strike the front or side glass. Figure 1 •••• www.beverage-air.com • Pg. 3 ••••...
The unit should be leveled prior to operation. Figure 3 The unit must have casters, 6” legs, or sealed to the floor per NSF guidelines as shown in Figure 4A and •••• www.beverage-air.com • Pg. 4 ••••...
PRODUCT LOADING The VM series of units are not intended to be a pull down refrigerator and as such the product must be loaded at their intended merchandising temperature.
The control has been factory-adjusted with a defrosting cycle scheduled to last 6 minutes every hour to ensure that the evaporator performs without any ice build-up. None of the factory-programmed electronic control parameters can be modified unless an access code is entered (only your distributor's technical personnel have that code). •••• www.beverage-air.com • Pg. 6 ••••...
Page 7
COMPRESSORS: The VM2, and VM7 has a single hermetic compressor. The VM12 and VM18 each have two hermetic compressors that start in two steps with a delay of 10 seconds to reduce the in-rush of current to the unit. CONDENSERS: The VM 7, 12, and 18 units incorporate a "maintenance free"...
VM2: 20 kg (44 Lbs) VM7, VM12: 50 kg (110 Lbs). VM18: 60 kg (132 Lbs) This load limits must not be exceeded to prevent potential damage to the shelf and/or injury to users.
4. Replace the grill assembly. 5. Connect power to the unit and verify that when required the condensing unit(s) are running. If you cannot remove the dirt adequately, please call your refrigeration service company. •••• www.beverage-air.com • Pg. 9 •••• FIGURE 10...
Page 10
If replacing parts is required, do it through your distributor. WARNING: Always ask for original spare parts AUTHORIZED DISTRIBUTOR: _____________________________________ COMMERCIAL NAME: _____________________________________ ADDRESS: _____________________________________ TELEPHONE: _____________________________________ E-MAIL: _____________________________________ •••• www.beverage-air.com • Pg. 10 •••• TECHNICAL ASSISTANCE...