Preventative Maintenance; Daily Exterior; Weekly Interior; Monthly Condenser - Beverage-Air RI Series Installation, Operation And Troubleshooting Manual

4.1 Daily, Exterior
1 - Clean the surface with a sponge and dilute mild detergent. Use a non-abrasive cleaner that
does NOT contain chlorine.
2 - Rinse with clean water before drying with clean soft cloth.
3 - Polish with a soft cloth, wiping with the grain of the metal.
4 - Once a week wipe with a film cutting agent or stainless steel polish to maintain finish.
4.2 Weekly, Interior
1 - Remove all food, food related items, and shelves.
2 - Disconnect power to the cabinet at the main power supply circuit breaker
3 - Remove loose food particles from interior floors, walls, and ceiling
4 - Scrub all interior surfaces and door gaskets with a warm (100-120F) detergent solution
and a soft nylon bristle brush
5 - Rinse with clean water and allow to air dry
6 - Re-install the shelves
7 - Restore power to the cabinet by resetting main power supply circuit breaker
8 - Return food to the cabinet when temperature indicator displays safe food temperature
4.3 Monthly, Condenser
The condenser coil is located right behind the front grille on top of the cabinet. It should be
inspected once a month and cleaned as required. Vacuum clean all surfaces of the condenser.
Make sure no fins are bent or damaged in the process. If there are bent fins, carefully straighten
them so that air can flow through the coils. Failure to keep the condenser coil clean will lead to
poor performance, excessive power consumption and compressor failure and may result in loss
of property. Failure to keep the condenser coil clean may void the limited warranty.
4.4 Periodic, Gaskets
1 Visually inspect the door gaskets for a tight seal on all four sides. Inspect for any type of
damage such as rips, tears, stiffness, or cracks.
2 If any such condition exists, the magnet will not seal and the gasket will need replaced.
3 Cleaning the gasket requires the use of mild dish detergent and warm water.
4 Next, thoroughly rinse and dry the gasket.
809-114A Rev B

PREVENTATIVE MAINTENANCE

20
2017-03-30