Table of Contents
Advertisement
en Troubleshooting
Fault
Plastic tableware is not dry.
Cutlery is not dry.
Appliance interior still wet
after wash cycle.
Remnants of food on table-
ware.
52
Cause
Not a fault. As plastic does
not store heat so well, it also
does not dry as well.
Cutlery not arranged prop-
erly in the cutlery basket or
cutlery drawer.
Not a fault. The condensa-
tion drying principle causes
water droplets in the tub –
they are indeed desirable
here. The moisture in the air
condenses on the inside
walls, runs off and is
pumped out.
Tableware is placed too
close together or basket is
overfilled.
Spray arm rotation is
blocked.
Spray arm nozzles are
blocked.
Filters are soiled.
Filters are inserted incor-
rectly and/or not engaged.
Washing programme selec-
ted too weak.
Tableware has been pre-
cleaned too intensely. The
sensors chose a weaker pro-
gramme. Stubborn soiling
cannot be entirely removed.
troubleshooting
No remedial action possible.
▶
Droplets can form on the cutlery con-
tact points.
"Arrange cutlery individually where
1.
possible." → Page 33
Avoid points of contact.
2.
No action required.
Arrange tableware with sufficient
1.
space in between.
The spray jets must reach the sur-
faces of the tableware.
Avoid points of contact.
2.
Arrange tableware so that it does
▶
not obstruct spray arm rotation.
Clean the "Spray arms" → Page 46.
▶
Clean the filters.
▶
→ "Cleaning filters", Page 45
Insert the filters properly.
1.
→ "Filter system", Page 45
Engage the filters.
2.
Select a more intensive washing
▶
programme.
→ "Programmes", Page 20
Adjust the sensitivity of the sensors.
▶
→ "Sensors", Page 13
Only remove large remnants of food
▶
and do not prerinse tableware.
Adjust the sensitivity of the sensors.
▶
→ "Sensors", Page 13
Advertisement
Table of Contents
