Switching Off The Water Softening System; Regeneration Of The Water Softening System - Siemens SN85E800BE User Manual

Table of Contents

Advertisement

en Water softening system
Do not use table salt.
Add the special salt to the dis-
penser.
1
Funnel
Fill the dispenser right up with spe-
cial salt. The water in the dis-
penser is displaced and forced
out.
Place the lid back on the dis-
4.
penser and turn to close.
Switching off the water
softening system
If you find the special salt refill indic-
ator irritating, e.g. when using com-
bined detergents with salt replace-
ment substances, you can switch the
salt refill indicator off.
Note
To avoid damage to the appliance, only
switch off the water softening system in
the following cases:
¡ The water hardness is max. 26 °E
and you are using combined deter-
gents with salt replacement sub-
stances. According to manufactur-
ers, combined detergents with salt
replacement substances can gen-
erally only be used up to a water
hardness of 26 °E without adding
special salt.
1
Depending on the appliance specifications
28
¡ The water hardness is 0 - 8 °E.
1.
2.
a
a The display shows H:xx.
a The display shows
3.
4.
a The water softening system is
Regeneration of the water
softening system
In order to obtain fault-free function of
the water softening system, the appli-
ance performs regeneration of the
water softening system at regular in-
tervals.
Regeneration of the water softening
system takes place before the end of
the main rinse cycle in all pro-
grammes. It will increase the run time
and consumption values, e.g. water
and electricity.
Overview of consumption values
with regeneration the water
softening system
Here you can find an overview of the
maximum additional run time and
consumption values during regenera-
tion of the water softening system.
Regeneration of the water softening
system after x rinse cycles
Additional run time in minutes
Additional water consumption in
litres
You do not need to use special
salt.
Press
⁠ .
To open the basic settings, press
for 3 seconds.
Press
or
repeatedly until the
display shows H:00.
To save the settings, press
for 3 seconds.
switched off and the salt refill indic-
ator is deactivated.
⁠ .
6
7
5

Advertisement

Table of Contents
loading

Table of Contents