About This User's Manual; Doc (Declaration Of Conformity); Federal Communication Commission Interference Statement - Weidmuller IE-WL-VL-AP-BR-CL User Manual

Industrial wireless access point/bridge/client
Table of Contents

Advertisement

Wi-Fi device IE-WL-VL-AP-BR-CL

About This User's Manual

This manual is mainly designed for, but not limited to, the following hardware and firmware for the
IE-WL-VL-AP-BR-CL:
Hardware Rev: 1.0.0
Firmware Ver: 1.7.8
You are strongly recommended to visit Weidmüller's website (http://www.Weidmueller.com/Downloads) and
find the latest product datasheet, firmware, HIG (Hardware Installation Guide), User's Manual and related
information.
NOTE
You can find out the hardware revision number of IE-WL-VL-AP-BR-CL on the side label of the device.
The firmware version number can be seen on the Overview page, as follow:

DoC (Declaration of Conformity)

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in
a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one of the
following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: To assure continued compliance, (example – use only shielded interface cables when connecting
to computer or peripheral devices). Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment. This transmitter must not
be co-located or operated in conjunction with any other antenna or transmitter.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
equipment should be installed and operated with a minimum distance of 20 cm between the radiator & your
body.
B-91
Supporting Information

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents