Syslog - Weidmuller IE-WL-VL-AP-BR-CL User Manual

Wi-Fi device IE-WL-VL-AP-BR-CL
Saving configuration to
RS232
EBR-MODULE RS232
Configuration reset to default
Power events
Power 1/2 transition (On -> Off)
PoE transition (On -> Off)
Power 1/2 transition (Off -> On)
PoE transition (Off -> On)

Syslog

This function provides the event logs for the Syslog server. The function supports up to three configurable
Syslog servers and Syslog server UDP port numbers. When an event occurs, the event will be sent as a Syslog
UDP packet to the specified Syslog servers.
Syslog Event Types
Detailed information for the grouped events is shown in the following table. Check the box for Enable logging
to enable the grouped events. All default values are enabled (checked). Detailed descriptions of the event types
are available in the System Logs section.
Syslog Server Settings
You can configure the parameters for your Syslog servers in this page.
Syslog server 1/ 2/ 3
Setting
IP address
Syslog port
Setting
Port destination
(1 to 65535)
The configuration is successfully saved/there is an error saving the
EBR-MODULE
configuration to
failure IE-WL-VL-AP-BR-CL cannot detect an
the console port.
The configuration is reset to factory default.
Event is triggered when...
The IE-WL-VL-AP-BR-CL is powered down in PWR1/2.
The IE-WL-VL-AP-BR-CL is powered down in PoE.
The IE-WL-VL-AP-BR-CL is powered via PWR1/2.
The IE-WL-VL-AP-BR-CL is powered via PoE.
Description
Enter the IP address of the 1st/ 2nd/ 3rd Syslog Server
Description
Enter the UDP port of the corresponding Syslog server
3-55
Web Console Configuration
.
EBR-MODULE RS232
EBR-MODULE RS232
at
Factory Default
None
Factory Default
514