Static Route (For Client-Router Mode Only) - Weidmuller IE-WL-VL-AP-BR-CL User Manual

Wi-Fi device IE-WL-VL-AP-BR-CL
Edge port
Setting
Checked/Unchecked
NOTE We recommend you set an edge port for the port, which is connected to a non-STP/RSTP sub-network or an
end device (PLC, RTU, etc.) as opposed to network equipment. This can prevent unnecessary waiting and
negotiation of STP/RSTP protocol, and accelerate system initialization. When an edge port receives BPDUs, it
can still function as an STP/RSTP port and start negotiation.
Setting an edge port is different from disabling STP/RSTP on a port. If you disable STP/RSTP, a port will not
deal with STP/RSTP BPDUs at all.
Port Status
Port Status indicates the current Spanning Tree status of this port. Use Forwarding for normal transmission,
or Blocking to block transmission.

Static Route (For Client-Router Mode Only)

The Static Route page is used to configure the IE-WL-VL-AP-BR-CL's static routing table.
Active
Click the checkbox to enable Static Routing.
Destination
Specifies the destination IP address.
Netmask
Specifies the subnet mask for this IP address.
Gateway
Specifies the IP address of the router that connects the LAN to an outside network.
Metric
Specifies a "cost" for accessing the neighboring network.
Interface
Specifies the designated network interface for this routing rule.
Description
Sets a port, which no BPDU expectedly goes through, as an
edge port
3-49
Web Console Configuration
Factory Default
Unchecked, except
AP port