Table of Contents
Advertisement
C. Ensure correct spray pattern
Make sure both boom nozzles are pointed toward the ground. If they are not,
loosen the nozzle retaining nut, orient the opening of the boom nozzle to point
straight down, then retighten the nozzle retaining nut.
D. Ensure uniform coverage
To ensure proper coverage, the height of the unfolded boom nozzles should be
about 21" from the ground. The sprayer must be level with the ground to get this
height.
The overall spray width is 120", but 1/3 or 40" of the overall spray pattern must be
overlapped to get equal coverage throughout the spray area.
Use the tables in Appendix A to determine what speed to drive your vehicle for the
desired application rate
E. Begin to spray
Turn the remote switch ON to begin spraying.
9. Leaving
If the sprayer must be left unattended at any time:
unattended
10. Discontinue
If the sprayer becomes clogged or inoperative during use, discontinue use
use if clogged or
immediately.
inoperative
- DO NOT attempt to service while chemicals are in the sprayer and power is
- Return to service area to review instructions for troubleshooting before attempting
Note: A reserve, clean container capable of holding at least 31 gallons should be kept for use when the sprayer tank
needs to be emptied temporarily for repairs. It is advisable to purchase a reserve tank suitable for chemical
storage from Northern Tool + Equipment for use in these circumstances. The container should be properly
labeled as to its contents if it is used.
Operation – Using the Sprayer
IMPORTANT: Make sure broadcast nozzles are oriented to spray straight down
before you start. An incorrectly positioned broadcast nozzle may spray chemicals
on you or others.
Note: It is not unusual for the operator to be exposed to chemical drips while
adjusting the broadcast nozzle. Chemical resistant gloves should be worn.
40"
a) Disconnect power to the sprayer.
b) Relieve system pressure by depressing the gun trigger.
c) Turn off the vehicle. Set brake or block the wheels.
connected.
to service.
40"
43
Nozzle retaining nut
Boom nozzle
21"
40"
Advertisement
Table of Contents
